Filter
Top Products
Chapter 4: 7401-4xxx Hardware Installation 4-21
Installing a 7401-4xxx on the EasyPoint 45
Pedestal
The 7401-4xxx terminal is shipped with the Table Top Mount attached.
Use the following procedure to mount a 7401-4xxx terminal on an
EasyPoint 45 Pedestal.
1. Unlock the Keylock.
2. Open the Display Door.
3. Slide the Keyboard Tray forward to access and remove the Table
Top Mount screws (2) under the keyboard at the front of the
terminal.
4. Slide the Remove the Table Top Mount from the bottom of the
terminal.
5. Attach the Table Top Mount to the top of the pedestal using the
four (4) screws.
Note: The EasyPoint 45 pedestal may be secured to the floor
before mounting the 7401-4xxx terminal onto the pedestal. Two
12.7 mm (0.5 in.) holes are provided in the base of the pedestal. Use
11 mm or 12 mm (0.375 in. to 0.5 in.) bolts or lag screws to secure
the pedestal to the floor.
Refer to the NCR EasyPoint 7401 Site Preparation Guide (B005-0000-
1255) for floor mounting details.
6. Route the AC power cord and network cable (if used) out the hole
in the bottom of the terminal and through the hole in the Table Top
Mount.
7. Slide the terminal into the Table Top Mount being careful not to
pinch the cables.
8. Secure the terminal to the Table Top Mount using the screws (2)
removed in Step 3.