Filter
Top Products
Chapter 5: Setup 5-3
Note: If you are not using an external keyboard, you can touch the
menu controls at the bottom of the screen. If you encounter difficulty
doing this, recalibrate the screen.
Setting the Date and Time
To set the date and time, perform the following steps:
1. In the Setup Main menu, move your cursor to the System Time field,
type the desired value, and press Tab or Enter to continue with the
next field.
2. Enter the desired date in the System Date field the same way as the
last step.
3. Move the cursor to the Exit menu, select Exit Saving Changes or
Save Changes, and press Enter.
Setting Passwords
To set passwords, perform the following steps:
1. Move the cursor to the Set Supervisor Password selection and press
Enter. The Set Supervisor Password menu displays. From this menu,
the person setting up the password system can set the security
password. Users can set user passwords.
2. Move the cursor to the Exit menu, select Exit Saving Changes and
press Enter.
Note: Only clear a password after obtaining the permission of the
responsible supervisor.
If the supervisor password is lost, it can be cleared by shorting the
appropriate pins on the main processor board. For the location of these
pins, refer to the EasyPoint 7401 Hardware Service Guide.
If the user password is lost, and the supervisor is not available, then
the above procedure can be used to clear the supervisor password.
Then new supervisor and user passwords can be defined.