Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Configuring Management Utilities 13-7
v1.0, June 2007
All the parameters listed in Table 13-4 can also be configured for a subset of all the access points
in the network by using the location code of the access points in the building.floor.location format.
The administrator can use 0 as the wild card value for any of the fields in this format. As an
example, all APs in building 10 can be represented by the location code 10.0.0. To configure the
SNMP parameters for a set of APs, follow these steps:
1. Navigate to the Configuration > Advanced > WLAN > Advanced page on the browser
interface of the master WFS709TP.
2. Determine if the required AP set already exists.
• If the required set does not exist, click Add to add the set of APs represented by a location
code, using 0 as the wild card value when required.(Figure 13-3).
• If the set already exists, click Edit for the chosen set and proceed to step 4 to configure the
SNMP parameters for the chosen set.
Privacy protocol An indication of whether messages
sent on behalf of this user can be
protected from disclosure, and if so, the
type of privacy protocol that is used.
This takes the value DES (CBC-DES
Symmetric Encryption Protocol).
Privacy protocol
password
If messages sent on behalf of this user
can be encrypted/decrypted, the
(private) privacy key for use with the
privacy protocol.
String password for DES.
Figure 13-3
Table 13-4. SNMPv3 Access Point User Details (continued)
Field Description Expected/Recommended Values