Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Deploying a Basic WFS709TP System 2-19
v1.0, June 2007
2. Select the AP that is to be configured from the list by selecting the checkbox to the left of the
AP and then clicking the Provision button.
3. On the Provision page (Figure 2-15), enter the location code in the format explained at the
beginning of this section.
4. Enter the antenna gain in dBi (for example, enter 5.0). This information is mandatory, as the
AP cannot bring up its radio interface or function as an AP without it.
5. Click Apply and Reboot to apply the configuration to the AP.
Figure 2-14
Figure 2-15
Note: The configuration does not take effect until the AP is rebooted