Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
Configuring WFS709TP for Voice 14-3
v1.0, June 2007
Limiting the Number of Active Voice Calls
You can limit the number of active voice calls allowed on a radio. This feature is disabled by
default. When the disconnect extra call feature is enabled, the system monitors the number of
active voice calls, and if the defined threshold is reached, any new calls are disconnected. The AP
denies association requests from a device that is on call.
You enable this feature in the WLAN configuration. You also need to enable call admission
control, which is disabled by default. You can also configure the number of simultaneous calls that
a radio can handle on a per-protocol basis.
To limit the number of active voice calls:
1. Navigate to the Configuration > Advanced > WLAN > Advanced page.
2. Click Add to add a new location.
3. Enter a location ID in the format building.floor.plan, where each value is an integer.
4. Click Add.
5. Select the General tab.
6. Select VoIP CAC Disconnect Extra Call.
7. Click Apply.
8. Select the 802.11b/g or 802.11a tab to configure radio settings.
9. Scroll to the bottom of the page to display VoIP parameters.
10. Select VoIP Call Admission Control.
11. Configure the Call Capacity for the VoIP protocol if needed.
12. Click Apply.