Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
2-2 Deploying a Basic WFS709TP System
v1.0, June 2007
• Set the IP address of VLAN 1.
• Set the default gateway to the IP address of the interface of the upstream router to which
you will connect the WFS709TP.
2. Connect the uplink port on the WFS709TP to the switch or router interface. By default, all
ports on the WFS709TP are access ports and will carry traffic for a single VLAN.
3. Deploy the APs. The APs will use the ADP protocol to locate the WFS709TP.
You would then configure the SSIDs with VLAN 1 as the assigned VLAN for all users.
Deployment Scenario #2
Figure 2-2
Data center
Floor 3
subnet
Floor 2
subnet
Floor 1
subnet
WFS709TP
is default
gateway
for clients