Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
RF Plan 4-9
v1.0, June 2007
Users
• Enter the number of users you expect to have on your WLAN in the Users text box.
• Enter the number of users per AP you expect in the Users/AP text box.
The numbers entered in the these two text boxes must be non-zero integers between 1 and 255,
inclusive.
Rates
Select the desired data rates from the pull-down menus for 802.11b/g and 802.11a.
High data transmission rates require an increased number of APs to be placed in your building.
Carefully evaluate the data rate needs of your users.
AM Modeling Parameters Page
The AM Modeling Parameters page (Figure 4-6) allows you to specify the information necessary
for RF Plan to determine the appropriate placement of your air monitors.
Controls on this page allow you to select the following functions, which are described in more
detail in this section:
Note: The Users text boxes are active only when the Capacity model is selected.
Note: The Rate pull-down menus are active only when the Coverage or Capacity design
models are selected.
Figure 4-6