Filter
Top Products
WFS709TP ProSafe Smart Wireless Switch Software Administration Manual
RF Plan 4-27
v1.0, June 2007
This example assumes the following:
• You do not care if you have coverage in the Shipping and Receiving areas.
• You do not want to deploy APs or AMs in the Lobby Area.
Create a Don’t Care Area
To create a Don’t Care area:
1. Click AP Plan in the Feature Tree at the left side of the browser window.
2. In the Planning page, click the New link in the Areas section under Floor 1.
This opens the Area Editor.
3. Type Shipping and Receiving in the Name text box in the Area Editor.
4. Select Don’t Care from the Type pull-down menu box.
5. Click Apply.
An orange box appears near the center of the floor plan.
The information you typed in the editor appears in the box. You see the name and type of area,
as well as the coordinates of the lower left corner and upper right corner of the box.
6. Using your mouse, click and drag the box over the Shipping and Receiving area.
7. Drag one corner of the box to a corresponding corner of the Shipping and Receiving area and
using one of the corner handles of the box, stretch it to fit exactly over the Shipping and
Receiving area.
Your floor plan with the Don’t Care box should look similar to Figure 4-27.
Note: You can zoom in on the floor plan using the Zoom pull-down near the top of
the AP Planning page, or type a zoom value in the text box at the left of the
pull-down and press the enter key on your keyboard.
Note: The x = 0 and y = 0 coordinates correspond to the lower left corner of the
layout space.