Filter
Top Products
Preparing for the CVX 600 Installation
296-1011-202 Rel. 5.0, Doc. Rev. 02.01 1-17
Chassis Installation
Mounting Hardware
To install the CVX 600 chassis in a rack, you need a Phillips #2 screwdriver and a
computer rack that meets the specifications listed in “Rack Requirements” on
page 1-7.
If the rack does not have threaded rail holes, you must use cagenuts and cagenut
screws (not supplied).
Note: Before you turn on the CVX 600, you should connect a local
terminal or PC to the CVX 600 console port. This console will display
diagnostic information. If there is a startup problem, in which case, you
need to contact Nortel Networks Technical Support (see “Customer
Services” on page xviii).