Filter
Top Products
147Setup
Chapter 1 DVS-9000 Functions
For details of saving and recalling setup data, see “Saving and Recalling Setup
Data” (page 148).
System reset and memory initialization (Initialize)
• Reset: Reset to state after powering on.
• All Clear: Clear the memory, and carry out initialization. The Network
Config, System Config, Format, and Start Up setup values are set by
reference to data stored in non-volatile memory, and the system
automatically starts up. It is not necessary to reset the Date/Time settings.
For more details, see “Saving and Recalling Setup Data” (page 148).
Installation (Install)
This installs the software and firmware in all devices (including the DCU)
connected to the Data LAN.
Standard Install mode: Installs the standard configuration.
There are also the following functions.
Detail Information: Gives details of the software and firmware installed in
each device.
Device management (Maintenance)
• Date and time setting
• Formatting a memory card
• Primary settings for USB external storage device
• Reloading a USB driver