Sony DVS-9000 Switch User Manual


 
Chapter 3 Transitions
236
Executing a Transition
Setting the Transition Rate
There are two ways of setting the transition rate: using the Flexi Pad control
block or numeric keypad control block to enter a numeric value, or using the
Misc menu to access the Transition menu for the M/E or PGM/PST bank.
Frame input mode and timecode input mode
For numeric input of the transition rate value, there are two modes: frame input
mode and timecode input mode. You select one of these modes using either the
Flexi Pad control block (page 237) or the numeric keypad control block (page
238).
Frame input mode: The entered value is a number of frames.
Example: Entering 123 constitutes an entry of 123 frames
Timecode input mode: The entered value is a timecode value.
Example: Entering 123 constitutes an entry of 1 second 23 frames.
Note
Whereas you can enter a value of up to 999 in frame input mode, a value not
smaller than 10 seconds cannot be entered in timecode input mode.
Frame display mode and timecode display mode
For the transition rate display in the transition control block, there are two
modes: frame display mode and timecode display mode. You can select one of
these modes in setup. (See “Operation Settings” in Chapter 16 (Volume 2).)
Note
The setting is common to all banks of the switcher.
Frame display mode: Values are shown as from 0 to 999 frames. In this
display mode, a value entered in timecode input mode is converted for
display as a number of frames.
Timecode display mode: Values are shown as timecode values, consisting of
seconds and frames. In this display mode, a value entered in frame input
mode is converted for display as a timecode value. If the value consists of
four or more digits, the last digit is not shown.
Example: A value of 9 seconds 23 frames appears as “9.23” and a value of
10 seconds 1 frame appears as “10.0.”