Filter
Top Products
Chapter 5 Wipes
318
Basic Procedure for Wipe Settings
1
In the M/E-1> Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
Press the [Multi] button, turning it on.
3
Set the following parameters.
a) See page 64.
4
To make more adjustments, press the [Multi Adjust] button.
The Multi Adjust menu appears.
5
Make the following settings, as required.
H Invert: When this is on, alternate tiles are inverted left-to-right.
V Invert: When this is on, alternate tiles are inverted top-to-bottom.
Non-Mask: When this is on, even if the positioner function is used to
move the pattern position, the pattern is always present on the screen.
Position: By adjusting the following parameters, move the pattern position
within the divisions determined in step 3.
a) See page 61.
Making a wipe pattern like a Venetian blind (Pairing)
Use the following procedure.
1
In the M/E-1 > Wipe menu, select HF5 ‘Main Modify.’
The Main Modify menu appears.
2
In the <Pairing> group, select the slit direction.
H: Create slits in the horizontal direction.
V: Create slits in the vertical direction.
Knob Parameter Adjustment Setting values
1 H Multi Number of repetitions of pattern
horizontally
1 to 63
2 V Multi Number of repetitions of pattern
vertically
1 to 63
3 Shift Replication layout
−100.00 to +100.00
a)
Knob Parameter Adjustment Setting values
1 Position H Horizontal position of pattern
−200.00 to +200.00
a)
2 Position V Vertical position of pattern
−200.00 to +200.00
a)