Filter
Top Products
Chapter 2 Menus and Control Panel
184
Names and Functions of Parts of the Control Panel
M/E3 (DEV3): device 3
P/P (DEV4): device 4
DME1 (DEV5): device 5
DME2 (DEV6): device 6
DME3 (DEV7): device 7
DME4 (DEV8): device 8
DME5 (DEV9): device 9
DME6 (DEV10): device 10
DME7 (DEV11): device 11
DME8 (DEV12): device 12
To exit from this mode, press the
[DEV] button again, turning it off.
When the [RUN CTRL] button is
selected: This enables the effect run
control mode in the device control
block.
The functions of the operation buttons,
trackball, and Z-ring vary with the
operation mode as follows.
b Operation buttons
When the positioner operation mode is
enabled
K1 CB1: Press this button to enable wipe
pattern position setting for key 1
(DSK1).
When the [USER] button is selected,
pattern position setting for color
background 1 is enabled.
K2 CB2: Press this button to enable wipe
pattern position setting for key 2
(DSK2).
When the [USER] button is selected,
pattern position setting is enabled for
color background 2.
K3 FM1: Press this button to enable wipe
pattern position setting for key 3
(DSK3).
K4 FM2: Press this button to enable wipe
pattern position setting for key 4
(DSK4).
MAIN: Press this button to enable main
wipe pattern position setting for normal
transitions.
SUB: Press this button to enable sub wipe
pattern position setting for normal
transitions.
Among the [K1 CB1] button, [K2 CB2]
button, [K3 FM1] button, [K4 FM2] button,
[MAIN] button, and [SUB] button, you can
make a multiple selection.
POS: Press this button to enable pattern
movement in the x-axis and y-axis
directions with the trackball.
When the [USER] button is selected,
this enables the trackball to move the
pattern in the x-axis and y-axis
directions, and the Z-ring to adjust the
size of the pattern.
X, Y: These restrict the axes affected by the
trackball and Z-ring to the x- or y-axis.
Z: This restricts the axes affected by the
trackball and Z-ring to the z-axis.
CTR (center): When this button is pressed,
the pattern position returns to the
center. When the [USER] button is
selected, the pattern size also returns to
50.00.
SHIFT/CLR WORK BUFR: These are
not used in positioner operation mode.
When the three-dimensional transform
operation mode is enabled
LOCAL: Enable operations in the DME
local coordinate space.
GLB (global): Enable operations in the
DME global coordinate space.
The [LOCAL] and [GLB] buttons can be
selected at the same time.
SRC (source): Enable operations in the
DME source coordinate space.
TRGT (target): Enable operations in the
DME target coordinate space.
The [SRC] and [TRGT] buttons cannot be
selected at the same time.
AXIS LOC (location): When this button is
lit, the trackball moves the rotational