Filter
Top Products
29Signal Selection
Chapter 1 DVS-9000 Functions
In addition to the signals input to the PRIMARY INPUTS 1 to 80 connectors
on the rear panel of the switcher, you can also select signals generated within
the switcher.
Each button has assigned to it a video signal and a key signal, forming a pair.
You can set these video and key combinations in a Setup menu.
For details of Setup menu operations, see “Cross-Point Settings (Xpt Assign
Menu)” in Chapter 16 (Volume 2).
Cross-point button control block button numbers
On each M/E bank and the PGM/PST bank, each cross-point button and reentry
button has two button numbers, and you use the shift button to switch between
these numbers.
In the case of a 32-button layout, the button numbers are as follows.
Switching button numbers
The rightmost (32nd) button functions as a shift button.
(The shift button function can be disabled in a Setup menu.)
When selecting the signals of button numbers 1 to 31, press the cross-point
button for the desired signal.
To select button numbers 32 to 62, hold down the shift button, and press the
cross-point button for the desired signal.
M/E
1
M/E
1
SHIFT
XPT
HOLD
XPT
HOLD
MCRO
ENBL
DSK3
KSK4
MCRO
ASGN
XPT
HOLD
XPT
HOLD
AUTO
RUN
UTIL
M/E
1
M/E
1
M/E
2
M/E
2
M/E
2
M/E
2
M/E
3
M/E
3
M/E
3
M/E
3
1, 2, 3, 4, ....... ....... 29, 30, 31 121 123
32, 33, 34, 35, ....... ....... 60, 61, 62 125 127
(first button numbers)
(second button numbers)
Shift button
Shift button
Cross-point control block button numbers
Button Number when the shift
button is not pressed
Number when the shift
button is pressed
From the left end to the 31st
button
1 to 31 32 to 62
Reentry buttons 121 to 123 125 to 127