Filter
Top Products
39Transitions
Chapter 1 DVS-9000 Functions
Time offset execution with the key not inserted
Transition Types
Selecting the transition type determines the way in which the transition occurs.
Carry out the type selection with the transition type selection buttons in the
transition control block of the M/E or PGM/PST bank.
For details of this operation, see “Basic Operating Procedure” (page 224).
The following are the transition types.
Mix
This is a dissolve, in which the new video progressively fades in over the
current video, with the sum of the two video outputs maintained constant. At
the mid-point of the transition (when the fader lever is in the center position),
the output of each is 50%.
This transition type can also be selected for an independent key transition. In
this case, the key either dissolves in or dissolves out similarly, with the
progress of the transition.
Common transition
(wipe) start
Independent key
transition (mix)
start
The transition
completes with the
key deleted.
Example 1: When the independent key transition [AUTO TRANS]
button is pressed later
Common
transition (wipe)
start
Independent
key transition
(mix) start
The transition
completes with the
key deleted.
Example 2: When the common transition [AUTO TRANS] button is
pressed later