Filter
Top Products
239Executing a Transition
Chapter 3 Transitions
To enter a difference from the current value
After pressing the [+/−] button, enter the difference and press the [TRIM]
button.
To change the sign (+ or −), press the [+/−] button.
Setting the transition rate by a menu operation
Use the following procedure.
1
In the M/E or PGM/PST menu, select first VF7 ‘Misc,’ then HF1
‘Transition.’
The Transition menu appears.
2
Select any transition type in the <Transition Type> group.
3
Turn the knob to set the transition rate.
Pattern Limit
There are two ways of setting a pattern limit: either by operating the fader lever
to save the fader position, or by using the Wipe menu or DME Wipe menu to
access the Edge/Direction menu for the M/E or PGM/PST bank.
For an overview of the pattern limits, see page 44.
Notes
• A pattern limit only applies when a wipe or DME wipe is selected as the
transition type.
• A pattern limit cannot be applied to an independent key transition (see page
248).
Knob Parameter Adjustment Setting values
1 Transition Rate Transition Rate 0 to 999 (frame count)