Filter
Top Products
251Independent Key Transitions
Chapter 3 Transitions
1
In the numeric keypad control block, hold down the [TRANS RATE]
button, and in the independent key transition control block, press the
delegation button [KEY1] to [KEY4] ([DSK1] to [DSK4] in the PGM/PST
bank) for the key for which you want to set the transition rate.
The numeric keypad control block changes to the mode for inputting the
independent key transition rate, and its display now shows the
corresponding region name and the current transition rate set for the
region.
2
With the numeric keypad, enter the transition rate.
• Enter a value of up to three digits.
• To clear the entry value, press the [CLR] button.
For details of frame input mode and timecode input mode, see page 236.
3
Press the [ENTER] button.
This confirms the entry, and the selected region name and the set transition
rate appear in the numeric keypad control block display.
To enter a difference from the current value
After pressing the [+/−] button, enter the difference and press the [TRIM]
button.
To change the sign (+ or -), press the [+/−] button.
Setting the independent key transition rate by a menu operation
Use the following procedure.
1
In the M/E or PGM/PST menu, select first the desired one from VF1
‘Key1’ to VF4 ‘Key4,’ then HF6 ‘Transition.’
The Transition menu for the selected key appears.
2
Select any transition type in the <Transition Type> group.
If, in the Setup menus, you set insertion/deletion as independent modes,
make the settings for insertion in the <On Transition Type> group, and the
settings for deletion in the <Off Transition Type> group.
3
Turn the knob to set the transition rate.
Knob Parameter Adjustment Setting values
1 Transition Rate Transition rate 0 to 999 (frame count)