Filter
Top Products
309Basic Procedure for Wipe Settings
Chapter 5 Wipes
• When morphing (see page 57) is selected
6
In the <Main/Sub Link> group, make the main/sub modifier link function
settings. (See “Main and sub modifier link function” (page 59).)
Full: full link mode
Semi: semi-link mode
Applying the effect of a diamond dust wipe to the selected
pattern (Dust mix)
Use the following procedure.
1
In the Pattern Mix menu, press [Dust Mix], turning it on.
2
Set the following parameters as required.
You can also apply the dust mix function to the pattern generated by a
pattern mix.
Note
When a rotary wipe (pattern numbers 100-107, 150, 151, 156, 158, 160,
162, 516, 518, 604, 606, 624, and 661) or random/diamond dust wipe
(pattern numbers 270-274) is selected, the dust mix function is not
available.
Setting Wipe Modifiers
You can apply various modifiers to the wipe pattern: setting the wipe direction,
pattern position, and so on.
Knob Parameter Adjustment Setting values
2 Start Point in transition at which main
pattern is at 100%
−50.00 to +150.00
3 End Point in transition at which sub
pattern is at 100%
−50.00 to +150.00
Knob Parameter Adjustment Setting values
1 Mix Ratio Proportion of diamond dust
pattern in mix
0.00 to 100.00
2 H Size Particle width 0.00 to 100.00
3 V Size Particle height 0.00 to 100.00
4 Flash Rate Rate of generation of particles 0.00 to 100.00