Filter
Top Products
311Basic Procedure for Wipe Settings
Chapter 5 Wipes
To specify the wipe direction with a button in the transition control
block
In the transition control block of each of the M/E-1 to M/E-3 and PGM/PST
banks, press the following direction selection buttons.
NORM: Normal
NORM/REV: Normal/reverse
REV: Reverse
Splitting the wipe pattern
Use the following procedure.
1
In the M/E-1 > Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
Press [Split], turning it on.
3
Set the following parameters.
Modifying the wipe pattern edge
Use the following procedure.
1
In the M/E-1> Wipe menu, select HF4 ‘Edge/Direction.’
The Edge/Direction menu appears.
2
In the <Edge> group, select the edge type.
Border: border
Soft: soft edge
Soft Border: soft border
For an overview of the edge types, see “Edge” (page 60).
3
Set the parameters according to the selection in step 2.
• When border is selected
Knob Parameter Adjustment Setting values
1 Split No. Number of splits 1 to 4 (integer)
2 Spacing Spacing between adjacent
patterns
0.00 to 100.00
Knob Parameter Adjustment Setting values
1 Width Border width 0.00 to 100.00