Filter
Top Products
Chapter 2 Menus and Control Panel
218
Basic Menu Operations
In the description of specific setting
procedures, the knob adjustment is
described, as follows.
Example: When wipe pattern key is
selected
When the [MENU] button in the device
control block is lit, you can use the trackball
and Z-ring to control the parameters.
• Move the trackball on the x-axis to
control the parameter for knob 1 or on the
y-axis to control the parameter for knob
2. Moving up or to the right increases the
parameter value, and moving down or to
the left decreases the parameter value.
• Use the Z-ring to adjust the parameter for
knob 3. Turning clockwise increases the
parameter value, and turning
counterclockwise decreases the
parameter value.
Going back to the previous menu
To return to the last displayed menu, press
the previous page button.
Numeric keypad window
a Item display
This is the name of the parameter being set
in the numeric keypad window.
b Max./min. (maximum/minimum)
value indication
This shows the maximum and minimum
settings of the parameter.
c Input value
This is the value being input into the
numeric keypad window.
d Close button
This closes the numeric keypad window.
e TC (timecode) button
When the numeric keypad window is
opened for a setting requiring a timecode
value to be entered, this button appears in a
depressed state.
Knob Parameter Adjust-
ment
Setting values
1Size Pattern
size
0.00 to 100.00
2 Soft Edge
softness
0.00 to 100.00
3 Density Key
density
0.00 to 100.00
1 Item display
2 Max./min. value indication
3 Input value
4 Close button
5 TC (timecode)
button
6 − (minus)
button
7 Clear button
8 Trim button
9 Enter button