3-60 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual • June 2006
3.4.14 Replacing PCI Cards
Follow these steps to remove and replace a PCI card.
Note – This component is a CRU and can be replaced by anyone.
TABLE 3-15 lists the qualified part numbers for this component. These part numbers
are subject to change over time. For the most up-to-date list of replaceable
components, product updates, and downloads, see the following URL:
http://www.sun.com/servers/entry/x4100/downloads.jsp
1. Power off the server as described in Section 3.2.1, “Powering Off the Server” on
page 3-2.
2. If the server is in a rack, slide it far enough from the rack so that you can remove
the main cover. If you cannot safely view and access the component, remove the
server from the rack.
3. Remove the main cover as described in Section 3.2.2, “Removing the Main Cover”
on page 3-3.
4. Locate the PCI card slot in which you will install or replace a PCI card.
The server is shipped with two PCI risers already installed in the low-profile PCI
card sockets.
TABLE 3-15 Sun Fire X4100 Supported PCI Card Part Numbers
Component Part Number
PCIX Cards
LSI single-port U320 SCSI HBA 375-3255
2-GB single-port x86 HBA 375-3253
2-GB dual-port Fibre Channel HBA 375-3108
4-GB single-port Fibre Channel HBA 375-3354
4-GB dual-port Fibre Channel HBA 375-3294
Sun 2-port 4x IB HCA, LP 375-3260
Dual Gigabit-Ethernet (copper) 371-0911
Dual Gigabit-Ethernet (Fibre Channel) 371-0912
Sun 10-GB Ethernet LP 375-3301
LSI single-port U320 SCSI HBA 375-3255