Sun Microsystems X4100 Server User Manual


 
4-38 Sun Fire X4100 and Sun Fire X4200 Servers Service Manual June 2006
4.4.9 Replacing the Graphics Redirect and Service
Processor (GRASP) Board
Follow these steps to remove and replace the Graphics Redirect and Service
Processor (GRASP) board.
Note This component is a FRU and should be replaced only by qualified service
technicians. Contact your Sun Service representative for assistance.
TABLE 4-9 lists the qualified part numbers for this component. These part numbers
are subject to change over time. For the most up-to-date list of replaceable
components, product updates, and downloads, see the following URL:
http://www.sun.com/servers/entry/x4100/downloads.jsp
1. Power off the server as described in Section 4.2.1, “Powering Off the Server” on
page 4-2.
2. If the server is in a rack, slide it far enough from the rack so that you can remove
the main cover. If you cannot safely view and access the component, remove the
server from the rack.
3. Remove the main cover as described in Section 4.2.2, “Removing the Main Cover”
on page 4-3.
Caution There is a power status LED (CR1) on the GRASP board that indicates
whether 3.3V standby power is reaching the GRASP board. The GRASP board is not
hot-swappable and should never be removed while this LED is lit.
4. Squeeze the plastic standoff that protrudes through the GRASP board to press the
standoff’s locking tabs. See
FIGURE 4-34.
If you have difficulty pressing the locking tabs with your fingers, you can use a pair
of long-nosed pliers.
TABLE 4-9 Sun Fire X4200 Supported GRASP Board Part Numbers
Component Part Number
GRASP board 501-6979