Sun Microsystems X4100 Server User Manual


 
Chapter 4 Maintaining the Sun Fire X4200 Server 4-5
4.2.4 Removing the Front Cover
1. Open the door to the fan bay. See FIGURE 4-4.
2. While holding the fan bay door open, slide the front cover toward the front of the
chassis approximately 0.25 inch (6 mm).
3. Raise the rear edge of the cover first and then lift it off of the chassis.
Note When you replace the front cover, place the front edge on the chassis first,
then set it down into the keyed slots on the chassis sides before sliding it back.
Note When you remove any cover, the intrusion switch that is on the front I/O
board automatically powers down the system to standby power mode.
FIGURE 4-4 Removing the Front Cover