Filter
Top Products
FC-22 ADJUSTMENT 1 - 84 January 2000 © TOSHIBA TEC
1.18 Key Copy Counter (MU-8, MU-10)
To make a key copy counter available, the following 2 components must be installed to the machine.
Counter socket
MU-10
Key copy counter
MU-8
<Installation procedure>
(1) Remove the rear cover.
(2) Remove the feed-side upper cover, and cut
open the window for the key copy counter.
(3) Pull out the harness connector from the hole
in the machine frame, and cut the shorting har-
ness of the connector. (Treat the cut harness
properly to avoid it causing a short-circuit with
the machine frame.) Then, disconnect the
dummy connector.
Dummy
connector
Socket attachment screw holes
Harness
connector