Filter
Top Products
FC-22 ADJUSTMENT 1 - 46 January 2000 © TOSHIBA TEC
1. 4 Automatic Adjustment of the Auto-Toner Circuit
With this copier, the filling and removing of developer material is automatically performed by opera-
tion from the control panel. In addition, the auto-toner sensor is automatically adjusted successively
after the automatic filling of developer material.
<Operation procedure>
Note: At the time of unpacking, if developer material is not filled, the steps (3) and (4) below do not need
to be performed.
(1) Remove the toner cartridges.
(2) While pressing [0] and [5] simultaneously, turn the power ON. The following appears on the display:
[0] [5]
100% A A3
[POWER]
ৎ TEST MODE
(3) Input a code with digital keys and press the [START] key.ৎThe developer material is removed.
Code 390 : All developer materials are removed (developer materials Y, M, C and K).
391 : All color developer materials are removed (developer materials Y, M and C).
392 : Only developer material K is removed.
(4) After all developer materials are removed, press the [INTERRUPT] key.
Time required for removing All developer materials : Approx.10 min.
Color developer materials only : Approx. 6 min.
Developer material K only : Approx. 3 min.
(5) Open the front cover, install the developer cartridge(s) and then close the cover.
* When installing or uninstalling the developer cartridge(s), it is necessary to open and close the
front cover.
(6) Input a code with digital keys and press the [START] key.
Code 200 : All developer materials 221 : Color developer materials only
204 : Developer material K only
100% 200 A3
(Code) ৎ [START] ৎ TEST MODE