Filter
Top Products
January 2000 © TOSHIBA TEC 1 - 19 FC-22 ADJUSTMENT
1. 2. 3 Test print mode (04)
In the 04 test print mode, you can print the test patterns matching with each item if you input the
following codes.
Code Types of test pattern Remarks
Paper size
11 2-pixel modulation pattern for creating
γ
table A3
12 3-pixel modulation pattern for creating
γ
table A3
13 1-pixel modulation pattern for checking
γ
table A3
14 2-pixel modulation pattern for checking
γ
table A3
15 3-pixel modulation pattern for checking
γ
table A3
24 Gray 2-pixel modulation pattern for checking
γ
table A3
25 Gray 3-pixel modulation pattern for checking
γ
table A3
204 Grid pattern (Printer reproduction ratio/Registration Pattern width: 1 dot, Pitch: 5mm A3/LD
adjustment pattern) (same as the adjustment pattern
by [05] mode [1][SETTINGS])
219 6% test pattern
220 8% test pattern None
230 Gradation check pattern (2 Pixels standard) Pattern width: 10mm, A3/LD
32 gradation steps
231 Gradation check pattern (3 Pixels standard) Pattern width: 10mm, A3/LD
32 gradation steps
234 Half tone A3/LD
256 Density check pattern A3/LD
291 2-pixel modulation pattern 1 for selecting pulse width A3
292 2-pixel modulation pattern 2 for selecting pulse width A3
Note: Full color (YMCK) mode is not available in 230, 231 and 234.
<Operation procedure>
Note: 1. When an error has occurred, it is indicated, but the recovery operation is not performed. So, turn the
power OFF and then back ON to clear the error.
2. During test printing, when "Wait adding toner" is displayed, the [STOP] key is disabled.
0 4
POWER OFF/ONSTOP
POWER
(Code)
(
Exit
)
(Test print operation)
START