Filter
Top Products
January 2000 © TOSHIBA TEC 4 - 41 FC-22 TROUBLESHOOTING
CC3 Bin-shift motor rotation abnormal
When the push switch SW2 or SW3 on the sorter controller board is pressed, does the bin unit
move upward (or downward)?
Replace the lead-cam home position sensor (PI2).
While the above procedure is proceeding, does the bin-shift motor rotate?
Check if the lead-cam drive belt is properly fitted on the sprocket.
Disconnect J15 on the sorter controller board. Does the resistance between J15-5 and J15-6
on the harness side measure approx. 3
Ω
?
Check the wiring up to the bin-shift motor (M2). If it is normal, replace the bin-
shift motor (M2).
Connect J15 on the sorter controller board. Having tester probes touch J15-5 (+) and J15-6
(–), press SW2; does the tester's pointer swing?
Replace the sorter controller board.
Replace the bin-shift motor (M2).
NO
YES
▼
▼
YES
NO
▼
▼
YES
NO
▼
▼
YES
NO
▼
▼