FC-22 ADJUSTMENT 1 - 52 January 2000 © TOSHIBA TEC
In accordance with the procedure described below, make adjustment of each adjustment item so that
the measured values obtained from test copies satisfy the specification. By pressing the [ENERGY
SAVER] key, immediately after starting the adjustment mode “05”, single-sided test copying can be
performed (normal copy mode).
[Procedure for inputting adjustment values]
0
1
5
POWER
SET
INTERRUPT
ENERGY
SAVER
Digital keys
START
: Input codes.
<Operation keys> <Display>
Varies with the code “XXX” entered with digital keys.
Current adjustment value
Adjustment value newly input
(If no input, YYY is displayed.)
Power OFF/ON
: Exit the adjustment mode.
Test copy
Digital keys
START
: Input adjustment
values.
Value ZZZ is stored
replacing values YYY.
If the test copy does not
satisfy the specified values,
return to the step 1 and
repeat the adjustment
procedure.
or
( CLEAR Use to make corrections)
100%
AA3
TEST MODE
100%
AA3
TEST MODE
100%
AA3
Wait Warming Up
100%
AA3
COPYING
Code No.
100%
YYY ZZZ
XXX A3
TEST MODE
