Filter
Top Products
FC-22 ADJUSTMENT 1 - 78 January 2000 © TOSHIBA TEC
(d) Installing the carriage drive wires to the wire pulleys
Ball terminal
Winding the wire to the wire pulleys:
1. Fit the 3-mm ball terminal in the center of the
wire into the hole in the wire pulley. The wire
should be positioned so that the part of the wire
with a hook on its crimped side be on the upper
side.
2. Wind the wires onto the wire pulleys on the front
and rear. The number of turns to be wound are
as follows (see the illustrations below):
· One turn on the inside of the boss.
· Six turns on the outside of the boss.
After winding the wires on the pulleys, hold the
wires with wire holder jigs to prevent them from
unwinding.
Wire pulley
[Rear side]
[Front side]
Ball terminal
1 turn
6 turns
Hook
Pulley
(rear)
Boss
Pulley (front)
Boss
Hook
6 turns
1 turn
Ball terminal
(Front)
Hook
Wire pulley
Wires
Ball terminals
(Rear)
Wire pulley
Wire holder jig