FC-22 ADJUSTMENT 1 - 20 January 2000 © TOSHIBA TEC
104 128 1~255
When the value increases by 1, the
reproduction ratio in the secondary
scanning direction (vertical paper
feeding direction) increases by
approx. 0.1522%.
105 128 85~171 When the value increases by 1, the
image shifts by approx. 0.1213mm
toward the trailing edge of the pa-
per.
106 For regular 180 5~251 When the value increases by 1, the
copy mode image shifts by approx. 0.042mm
toward the front side of the paper
(machine).
108 For whole-area 133 5~251 When you input a value, which is
copy mode 47steps (equivalent to2mm)
smaller than the set value of [106],
the rear original edge and thefront
copy edge match (0.042mm/step).
135 RADF original stop position (single-sided) 8 0~15 Changes the position where the
136 RADF original stop position 8 0~15 original stops.When the value in-
(reverse side of two-sided original) creases by 1, the original stop po-
sition shifts by 1 mm away from the
original stopper.
137 RADF sensor automatic adjustment and – – By pressing the START key, WAIT
EPROM Initialization is displayed while the automatic
adjustment is performed.
Perform RADF EPROM Initializa-
tion when EPROM, RADF logic
PWA or sensors are replaced.
142 RADF 2-in-1 gap adjustment 8 0~15 When the value increases by 1, the
gap between two originals extend
by 1 mm.
1. 2. 4 Adjustment mode (05)
In the adjustment mode 05, the following adjustment items can be corrected, changed, or checked.
Acceptable
Operation
Code
Description/Mode
Default
Value
Contents
procedure
group
1
1
1
1
1
1
6
1
Scanner (secondary scanning) copy length re-
production ratio adjustment.
Scanner (secondary scanning) start position
deviation
CCD primary scanning start
position deviation
*In code No. column, number after hyphen means sub-code.
