Filter
Top Products
3.27 IEEE1394 test program 3 Tests and Diagnostics
3.27 IEEE1394 test program
This section describes how to perform the IEEE1394 test with the test program.
NOTE:
Use another computer that can communicate by IEEE1394 (i. Link) cable as a
reference machine to perform this test.
Toshiba MS-DOS is required to run the DIAGNOSTICS TEST PROGRAM. To start the
DIAGNOSTIC TEST PROGRAM, follow these steps:
(a) Insert the Diagnostics disk in the floppy disk drive and turn on the computer.
(The Diagnostics Disk contains the MS-DOS boot files.)
The following menu will appear:
********************************************************************
* XXXXX IEEE1394[XXXXX] Diagnostics program *
********************************************************************
* *
* 1 ....Transmit & Receive test *
* *
* 2 ....Responder set *
* *
* 3 ....1394 GUID Display *
* *
********************************************************************
.... Press test number[1-3] ?
(b) To execute the TEST, select the test number you want to execute and press Enter.
Subtest 01 Transmit & Receive test
This program checks the data transporting between responder machine and
target machine.
Subtest 02 Responder set
This program initializes the machine responder.
Subtest 03 1394 GUID Display
This program checks the GUID.
Satellite M30-35 Maintenance Manual (960-455) 3-57