Filter
Top Products
4.29 Fluorescent Lamp 4 Replacement Procedure
Assembly of Cover bottom, Sheets, Light guide, Tape Adhesive, Double Tape and
Board Ass’y.
To assemble the 15.4-inch WXGA LG.Philips fluorescent lamp, follow the steps below and
refer to figures 4-66 to 4-69.
1. Detach a protect film from Double Tape at the Lamp Ass’y.
2. Attach the Lamp Ass’y to the Support Main.
3. Detach a protect film from Double Tape at the inside of Cover Bottom.
4. Assemble the Cover Bottom and Screw to the Support Main.
CAUTION: Maximum value of torque with Screw should be below 3.0kgf·cm.
5. Assembly of Light Guide and Sheets.(Reflector Sheet fixing with one Double Tapes)
CAUTION: No penetration of foreign body is indispensable with no scratch on the
surface of each.
6. Assembly of Tape adhesive used for Sheets fixing (5Point)
7. Assembly of Board Ass’y
CAUTION: Pressure or stress should not be given on PCB and TCP.
Figure 4-66 Replacing LG.Philips fluorescent lamp (WXGA) (5)
Satellite M30-35 Maintenance Manual (960-455) 4-93