Filter
Top Products
4 Replacement Procedures 4.17 CD-Key assembly
4.17 CD-Key assembly
Removing the CD-Key assembly
To remove the CD-key assembly, follow the steps below and refer to figures 4-25.
1. Disconnect the CD-key flexible cable from the connector PJ7000 on the system
board.
2. Remove the following screw and the CD-key assembly.
• M2×4B BIND screw ×1
M2
×
4
B
BIND
CD-key flexible cable
CD-key
Figure 4-25 Removing the CD-key assembly
Installing the CD-Key assembly
To install the CD-key assembly, follow the steps below and refer to figures 4-25.
1. Place the CD-key assembly and secure it with the following screw.
• M2×4B BIND screw ×1
2. Connect the CD-key flexible cable to the connector PJ7000 on the system board.
4-46 Satellite M30-35 Maintenance Manual (960-455)