Filter
Top Products
4 Replacement Procedures 4.28 LCD cable/Wireless LAN Antenna/Hinge
Installing the LCD cable/Wireless LAN Antenna
To install the wireless LAN antenna/Bluetooth antenna/display cover/speaker, follow the
steps below and refer to figures 4-43 to 4-50.
1. Pass the LCD cable through the slot and guide.
2. Set the hinge (on the opposite side of the LCD cable) and secure it with the following
screws.
• M2×4B S-FLAT HEAD screw ×1
• M2.5×5B FLAT HEAD screw ×1
3. Place the circle plate and secure it with the following screws.
• M2×4B S-FLAT HEAD screw ×2
4. Set the hinge (LCD cable side) and secure it with the following screws.
• M2×4B S-FLAT HEAD screw ×1
• M2.5×5B FLAT HEAD screw ×1
5. Secure the hinges on the display cover with the following screws.
• M2.5×4B FLAT HEAD screw ×2
6. Install the hinge cap (on the LCD cable side).
7. Pass the wireless LAN antenna cables through the hole to the back.
8. Arrange the wireless LAN antenna cables along the guides on the back and fix them
with two acetate tapes.
9. Secure the wireless LAN antenna cables with the four acetate tapes.
4-74 Satellite M30-35 Maintenance Manual (960-455)