Filter
Top Products
4.18 System Board 4 Replacement Procedures
Satellite M30-35 Maintenance Manual (960-455) 4-49
Installing the System Board
To install the system board, follow the steps below and refer to figures 4-26 and 27.
1. Install the system board from the left side.
NOTE: When installing the system board, be careful not to pinch or damage the USB
cable, RGB cable, battery cable speaker cable, network cable, fan cable or
power cable.
2. Secure the system board with the following screws.
• M2.5×6B FLAT HEAD screw ×1
3. Connect the USB cable to the connector PJ7005 on the system board and stick the
glass tape.(VRAM64 only)
4. Connect the fan cable to the connector PJ8770 on the system board.
5. Connect the RGB cable to the connector PJ5621 on the system board and stick the
glass tape.
6. Connect the battery cable to the connector PJ8810 on the system board.
7. Connect the power cable to the connector CN3 on the power board.
8. Connect the USB cable to the connector PJ7003 on the system board.
9. Connect the speaker cables to the connectors PJ6003 and PJ6004 on the system
board.
10. Connect the network cable to the connector PJ4100 on the system board and stick
the glass tapes.