Filter
Top Products
4 Replacement Procedure 4.29 Fluorescent Lamp
5. Removing PCB-ASSY cell
1) Remove the PCB-ASSY cell from the backlight unit.
2) Remove the double-sided adhesive tape from the back of the cell.
NOTE: 1) Remove the tape slowly not to break the cell. The cell and frame are
glued by double-sided adhesive tape.
2) Be careful not to remove the light shielding tapes from the upper left
and right sides of the cell.
PCB-ASSY cell
Backlight unit
Remove the cell by
peeling off the double-
sided adhesive ta
p
e.
Figure 4-55 Replacing TMD fluorescent lamp (WXGA) (5)
4-82 Satellite M30-35 Maintenance Manual (960-455)