Filter
Top Products
4 Replacement Procedure 4.29 Fluorescent Lamp
6. Sticking tapes and insulation sheets
1) Stick the Y-PCB insulation sheet and X-PCB insulation sheet in order.
2) Stick the two bezel tapes on the lower side (lamp side).
3) Stick the fixing tape for FL cable.
NOTE: Be careful not to damage to the TAB or the pulling-out part of lamp
cable when sticking the tapes and insulation sheets.
Stick the X-PCB
insulation sheet.
Stick the Y-PCB
insulation sheet.
Stick the insulation sheet
without any flexure.
Stick the insulation sheet
without any flexure.
Stick the bezel tape while pressing
not to cause floating of bezel.
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
Standard for sticking bezel
tape. Stick the tape between
the mark-off lines.
Standard for fixing
tape for FL cable.
Fixing tape for FL cable
Bezel tape
Figure 4-61 Replacing TMD fluorescent lamp (WXGA) (11)
4-88 Satellite M30-35 Maintenance Manual (960-455)