Filter
Top Products
4 Replacement Procedures 4.22 USB Board/DC-IN jack/Network jack
4.22 USB Board/DC-IN jack/Network jack
Removing the USB Board/DC-IN jack/Network jack
To remove the USB board/DC-IN jack/network jack, follow the steps below and refer to
figure 4-34.
1. Remove the following screw securing the USB board.
• M2.5×4B FLAT HEAD screw ×1
2. Disconnect the USB cable from the connector CN1 on the USB board.
3. Peel off the acetate tape and remove the network jack from the slot.
4. Disconnect the DC-IN jack cable from the connector CN1 on the power board and
remove the DC-IN jack.
M2.5
×
4B FLAT HEAD
USB board
DC-IN jack
Network jack
USB cable
A
cetate tape
Figure 4-34 Removing the USB board/DC-IN jack/network jack
4-56 Satellite M30-35 Maintenance Manual (960-455)