Filter
Top Products
4.8 Wireless LAN board 4 Replacement Procedures
4.8 Wireless LAN board
CAUTION: The power must be turned off when you remove the wireless LAN board.
Removing the wireless LAN board with the power on risks damaging the
card or the computer itself.
Never press hard or bend the wireless LAN board.
Removing the wireless LAN board
To remove the wireless LAN board, follow the steps below and refer to figure 4-10.
1. Turn the computer upside down.
2. Loosen the screw fixing the wireless LAN board cover.
• M2×4B BIND screw ×1
Or
• M2×4 LH STICK screw ×1
3. Peel off the glass tape and disconnect the two wireless LAN antenna cables (black
and white) from the wireless LAN board.
4. Open the left and right latches holding the wireless LAN board and remove it.
Wireless LAN board
Antenna cable (black)
Antenna cable (white)
Wireless LAN board cover
Glass tape
M2
×
4B BIND or M2
×
4 LH STICK
Figure 4-10 Removing the wireless LAN board
Satellite M30-35 Maintenance Manual (960-455) 4-23