Filter
Top Products
Search and Close Call Options
109
Setting the Delay Time
Setting the Search Frequency Step
Srch/CloCall Opt
Set Delay Time
Off
1-5sec
2 sec
Srch/CloCall Opt
Set Step
Auto
5.0 kHz , 6.25kHz , 7.5 kHz , 8.33kHz ,
10.0 kHz , 12.5 kHz , 15.0 kHz , 20.0
kHz , 25.0 kHz , 50.0 kHz , 100.0 kHz
Auto
Auto Manual Default
This setting determines how long the scanner waits
after a transmission ends before resuming quick
search or Close Call operation. Select your setting,
then press the scroll control.
The scanner resumes immediately when the
transmission ends.
The scanner waits the set amount of time
after the transmission ends before resuming.
The default setting is .
This setting selects the frequency step used for
setting the channels. Select your setting, then press
the scroll control.
The step is based on the band (see the table at
the front of the manual)
The scanner uses the selected step.
The scanner defaults to .
This setting selects the APCO 25 threshold level
between , and . Select your
setting, then press the scroll control.
Note:
Note:
APCO 25 Threshold Level Setting
Srch/CloCall Opt
Adjust P25 Level