Filter
Top Products
2. Install 3 AA batteries,
matching the polarity
symbols (+ -).
Set to for use only with
rechargeable batteries. Never attempt to recharge
non-rechargeable batteries. Non-rechargeable
batteries can get hot and can even burst if you try
to recharge them.
3. Replace the cover.
When flashes and the scanner beeps every 15
seconds, replace the batteries.
You can also use three rechargeable batteries to
power your scanner. Before you use rechargeable
batteries, you must charge them. The scanner has a
built-in circuit that lets you recharge batteries while
they are in the scanner. To charge the batteries, set
inside the battery compartment to
, install the batteries in the scanner, and
connect the supplied AC adaptor to the scanner's DC
6V jack (see “Using AC Power” on Page 30).
Do not connect the AC adaptor to the scanner if
non-rechargeable batteries (such as alkaline
batteries) are installed in the scanner and
is set to , or if you are
unsure of the switch's position. Non-rechargeable
batteries can get hot and can even burst if you try
to recharge them. Before you use rechargeable
batteries for the first time, charge them for 14
hours to bring them to a full charge. Discharged
batteries take about 14 hours to fully recharge.
WARNING!
ALKALINE/Ni-MH Ni-MH
ALKALINE/ Ni-MH
NI-MH
WARNING!
ALKALINE/Ni-MH NI-MH
Using Rechargeable Batteries
Setting Up Your Scanner
29