Filter
Top Products
Setting Up Your Scanner
30
If an AC adaptor is connected to the scanner, the
scanner checks the condition of the installed batteries.
If the scanner is turned off and the batteries require a
full charge, appears on the display.
Then, appears as the batteries
are recharged. When the batteries are fully charged,
appears.
If no batteries are installed in the scanner,
appears. If there is a problem with the
installed batteries, appears. If the
installed batteries are batteries but
is set to ,
appears and the scanner does not charge the
batteries.
Before you use the scanner, remove the protective
plastic sticker over the display.
You can power the scanner using the supplied 6V,
800 mAAC adaptor.
To use the scanner on
AC power, plug the
adaptor into
on the right side of the
scanner, then plug the
AC adaptor into a
standard AC outlet.
If rechargeable batteries are installed and
is set to , the adaptor powers the
scanner and recharges the installed batteries at the
same time.
To prevent damage to Ni-MH batteries, never
charge them in an area where the temperature is
above 113°F (45°C) or below 32°F (0°C).
Pre-Charging
Normal Charging
Charge Complete
No
Battery
Battery Error
Charge Off
Ni-MH
ALKALINE/Ni-MH ALKALINE
6V 800 mA
ALKALINE/
Ni-MH NI-MH
WARNING!
Removing the Display Sticker
Using AC Power