Filter
Top Products
Programming/Editing Optional Settings
72
Setting the System Hold Time
Setting the Channel Delay Time
Program System
Edit Sys Option
Set Hold Time
Program System
Edit Sys Option
Set Delay Time
Select the system
This setting controls how many seconds the scanner
scans a system before moving to the next unlocked
system. Enter a value from 0-255, then press to
save the setting.
• This setting is available only when a control
channel exists in a trunked system.
• If you select 0, the scanner stays on the system
for a minimal time (only long enough to check cur-
rent system activity).
• The default setting is 2 seconds for each system.
• For conventional systems, all unlocked channels
will be scanned at least once regardless of this
setting.
• The scanner moves to the next system after the
hold time expires, any current transmission ends,
and the channel delay time expires.
• Due to the control method for these system types,
the scanner always scans LTR and EDACS SCAT
systems for at least 1 second.
Select the system
This setting controls how many seconds the scanner
waits after a transmission ends before resuming
E
Notes: