Filter
Top Products
Other Settings
54
Then set the scanner containing the programming you
want to transfer as the master scanner, then set the
other scanner as the slave scanner.
(Master scanner)
(Slave scanner)
When you are ready to clone the scanner, press
on the slave scanner first, then on the master scanner.
The master scanner checks the connection between
the two scanners, then transfers its data to the slave
scanner.
When the transfer is complete, appears on
both scanners. If the transfer did not work,
appears on the master scanner.
You can clone (copy) data from a PC to a UBCD396T
scanner. This is useful if you want to quickly program
20 or more UBCD396T scanners at the same time.
On-air cloning is practical if you are
programming more than 10 scanners at the same
time. Otherwise, we recommend you use wired
Programming.
• Start on-air cloning.
• Lets you set the frequency where
your scanner receives the cloning broadcast.
• Lets you set the cloning
broadcast’s modulation type.
To clone (copy) data from a PC to the scanner, you
need a transceiver, a PC that has an audio input, and
a cable to connect your PC’s sound card to the
transceiver. Follow the directions supplied with the
Uniden Advanced Scanner Director Software
(available online at www.uniden.com.au (for Australia)
or www.uniden.co.nz (for New Zealand)) to construct
a cable and use on-air cloning.
Clone Master Press SCAN Key
Clone Slave Press SCAN Key
Complete
Error
Xfer Information
On-Air Clone
Start Cloning
Set Frequency
Set Modulation
On-Air Cloning
Note: