Filter
Top Products
Other Settings
53
Use the included connection cable to connect your
scanner to another UBCD396T scanner or your
personal computer.
Lets you set the baud rate your scanner
uses to communicate with a personal computer.
• The baud rate is not set.
• The baud rate is set to 9600 bps.
• The baud rate is set to 19,200 bps.
• The baud rate is set to 38,400 bps.
• The baud rate is set to 57,600 bps.
• The baud rate is set to 115,200 bps.
Lets you set your scanner as a master (source) or
slave (recipient), letting you transfer programming to
or from another UBCD396T scanner. See "Wired
Cloning" on Page 53 (below) and "On-Air Cloning" on
Page 54.
• Sets the scanner to be the source
scanner.
• Sets the scanner to be the recipient
scanner.
To clone (copy) data directly from one UBCD396T
scanner to another UBCD396T scanner, you must
first connect the scanners to each other using the
included connection cables and a DB9 null modem
adaptor and DB9 gender changer (neither
included), available at most computer stores. Then
you must set one scanner as the source and the
other as the destination.
Plug the smaller end of each of the included
connection cables into on the right side of
each scanner. Then connect the other end of the
cables together using the null modem connector
and gender changer.
Settings
PC Control
PC Control
Off
9600 bps
19200 bps
38400 bps
57600 bps
115200 bps
Xfer Information
Wired Clone
Master
Slave
Using the Cloning Options
Wired Cloning
Remote