Filter
Top Products
Using Tone-Out
110
Fire Tone-Out Introduction
Your scanner can be set to respond to fire tone-outs
that use standard two-tone sequential paging, short
one-tone paging, and long group tone paging. You can
save up to 10 settings. When you select a setting in
standby mode, the scanner also monitors for any
other setting that uses the same transmit frequency,
modulation, and attenuation settings.
You need tone-out setup information from the agency
you wish to monitor. Check with your local agency or
on-line resources.
The Fire Tone-Out feature is not used in
Australia or New Zealand.
Turn the scroll control to select the tone-out to
monitor. All tone-outs that have the same frequency,
modulation, and attenuation setting as the one you
select, are also monitored.
In standby mode, the display cycles through all
monitored tone-out settings. Regardless of the current
display, the scanner always alerts on any received
tone-out that matches a stored setting.
If you press while in standby mode, the
scanner temporarily exits the mode and you hear all
transmissions on that frequency. No alerts sound,
even if a tone-out matches one you have stored.
Press again to return to standby mode.
Scroll to select the tone-out (1 - 10) you want to
program, then press . Then you can scroll to
any of the following settings and press to select
and modify the selected settings:
Note:
HOLD
HOLD
EYES
EYES
Setting Tone-Out Standby
Setting Up Tone-Out
Tone-Out for...
Tone-Out Standby
Tone-Out for ...
Tone-Out Setup
Using Tone-out