Filter
Top Products
Programming Radio Systems
57
Programming Conventional Systems
Entering/Editing Conventional
Channel Groups
Setting Up a Channel Group
Program System
New System
Conventional
Confirm? Yes=”E” / No=”.”
System n C
n
C
Program System
Edit Group
New Group
The scanner creates an empty conventional system,
with a default name of .
is a number that increments as you add new
systems. indicates that this is a conventional
system.
Refer to the appropriate section to set system-wide
options:
• See "Editing the System Name" on Page 70
• See “Editing the System Quick Key” on Page 71
• See “Setting System Lockout” on Page 71
• See “Setting the System Hold Time” on Page 72
• See “Setting the Channel Delay Time” on Page 72
• See “Deleting Systems” on Page 81
• See “Copying Systems” on Page 81
• See “Entering/Editing Conventional Channel
Groups” on Page 57(below)
To enter channels in a conventional system, first set
up a channel group (or groups) to hold the channels.
Then, enter the channel and channel parameters in
the group(s).
Select the system