Filter
Top Products
6-1
365-360-001R6.0
Issue 1, December 2008
............................................................................................................................................................................................................................................................
6 Configuring 8950 AAA
Realm Routing Table
Properties
Overview
Purpose
This chapter discusses the process of configuring the Realm Routing Table.
The following topics are included in this chapter:
Configuring Realm Routing Table
Introduction
The Policy Server uses the entries in the Realm Routing table to determine how to route
Diameter requests. The Policy Server uses the realm, Diameter application, vendor and
packet type of the Diameter request to match Realm Route entries. Once a match is found,
the request is routed locally, proxied, or redirected based on the Action in the entry.
Using the SMT to Configure Realm Routing Table
This section describes how to configure a 8950 AAA Realm Routing Table. The specific
procedure that follows lists steps to configure or modify an existing Realm Routing Table
using the Server Management Tool. For information about running the SMT, please refer
to “Starting the Server Management Tool”.
1. Select Realm Routing Table from the Configuration Tools folder on the Navigation
pane, as shown in Figure 6-1.
Configuring Realm Routing Table 6-1