Filter
Top Products
Black Box Hard et Switch ened Managed Ethern
(no) duplex MODE
MODE specifies the duplex m
4. Example:
The following example shows the use of du
fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#duplex full
switch_a(config-if)#
ode: auto, full, half.
plex MODE (full) to the interface
Flow control:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Termin
Then logon to Interface mode.
fe1 means port 1.
The switch_a(config-if)# prompt will show on the
switch_a(config)#interface fe1
switch_a(config-if)#
al Mode).
screen.
2. Usage:
Use flowcontrol on command to enable flow control, and configure the flow
control mode for the port.
Use the no flowcontrol to disable this function.
3. Command Syntax:
flowcontrol on
no flowcontrol
4. Example:
The following example shows the use of flowcontrol on to the interface fe1
(port 1):
switch_a(config)#interface fe1
switch_a(config-if)#flowcontrol on
switch_a(config-if)#
Port Status
1. Command Mode: Exec mode or Privileged Exec mode
Logon to Exec Mode (View Mode) or Privileged Exec Mode (Enable Mode).
The switch_a> or switch_a# prompt will show on the screen.
switch_a>
switch_a#
2. Usage:
Use the show interface command to display interface configuration and
User’s Manual 101