Filter
Top Products
Black Box Hard et Switch ened Managed Ethern
switch_a(config-if)#
2. Usage:
Use ip igmp query-max-resp to configure the
frequency of sending IGMP host query me
To return to the default frequen
query-max-response-time command.
3. Command Syntax:
ip igmp query-max-response-time RESPONSETIME
no ip igmp query-max-response
RESPONSETIME <1-240> Maximum
advertised in IGMP queries.
4. Example:
The following example configures a maxim
the interface fe1 (port 1):
switch_a(config)#interface fe1
switch_a(config-if)#ip igmp query-max-res
onse-time command
ssages.
cy, use the no ip igmp
-time
response time (in seconds)
um response time of 8 seconds on
ponse-time 8
IGMP passive snooping:
Static mc router port:
1. Command Mode: Interface mode
Logon to Configure Mode (Configure Terminal Mode).
Then logon to Interface mode.
vlan1.1 means vlan 1.
The switch_a(config-if)# prompt will show on the screen.
switch_a(config)#interface vlan1.1
switch_a(config-if)#
2. Usage:
Use ip igmp snooping mrouter interface command to statically configure
the specified VLAN constituent interface as a multicast router interface for
IGMP Snooping in that VLAN.
Use the no ip igmp snooping mrouter interface command to remove the
static configuration of the interface as a multicast router interface.
3. Command Syntax:
(no) ip igmp snooping mrouter interface IFNAME
IFNAME Specify the name of the interface
4. Example:
The following example shows interface fe1 (port 1) statically configured to be
a multicast router interface on vlan1.1:
switch_a(config)#interface vlan1.1
switch_a(config-if)#ip igmp snooping mrouter interface fe1
User’s Manual 147